Large Walk-in Environmental Test Chamber Walk-in Climate Test Chamber
Complied Standards & Clauses
Applied Standard:
IEC60068-2-1:2007 Environmental Testing-Part 2-1: Tests-Test A: Cold, IDT
IEC60068-2-2:2007 Environmental Testing-Part 2-1: Tests- Test B-Dry heat, IDT
IEC60068-2-78:2001 Environmental Testing-Part 2-78: Tests-Test Cab: Damp heat, steady state, IDT
IEC60068-2-22:2005 Environmental Testing Part 2-22: Tests Test N: Change of temperature, IDT
Product Overview
This equipment is suitable for high and low temperature tests on electrical, electronic, mechanical and large parts, semi-finished products, finished products, etc. It can simulate high and low temperature changes to test the quality and reliability of products and parts.
Sample Restrictions:
- Testing and storage of samples of volatile substances;
- Testing and storage of samples of corrosive substances;
- Testing or storage of biological samples;
- Testing and storage of samples of strong electromagnetic radiation sources.
Technical Parameters
| Workshop dimensions | Width 1300mm × Depth 1300mm × Height 2000mm |
| Outer dimensions | Chamber body is approx. Width 1600mm × Depth 1900mm × Height 2450mm (excluding motor protrusion height) Subject to actual size |
| Door | 1) Double-door hinged door, door opening size 2 meters wide × 2 meters high, two silicone rubber seals and anti-frost electric heating device on the door frame; 2) Door sealing: high and low temperature resistant high-quality sealing strips are used, with good sealing; 3) Condensation elimination: electric heating is pre-buried around the door to prevent condensation at low temperatures; 4) Safety protection: The door can be opened from the inside and outside, the inner box has a safety hammer escape device, and the safety equipment is running an emergency stop switch (with a protective cover) to ensure the personal safety of the operator. |
| Observation window | Two hollow glass observation windows, one on each side of the test chamber door, size: 400×600mm (width×height) |
| Test lead hole | Wiring holes: 2 100mm, 1 on each side of the door opening. The host is on the right, the cabinet is on the left. There is one more wiring hole on the right side of the cabinet. |
| Lighting | The top of the studio is equipped with a high and low temperature explosion-proof lamp to facilitate observation of the sample test status |
| Structural strength | Test box bottom plate load-bearing capacity: ≧100KG (uniform load) |
| Warehouse board inner wall material | SUS304 stainless steel, thickness 1.0mm |
| Warehouse board outer wall material | Colored steel plate |
| Insulation material | Hard polyurethane foam material, thickness 100mm |
| Warehouse base, electric control box and freezer | Using national standard angle iron + 6# channel steel + steel plate spraying |
| Pressure balance port | There is a pressure balance port on the top of the working room: when the pressure in the box is too high, it will be automatically discharged. Rapidly reduce the pressure in the cabin, equipped with a safety shield. |
| Ramp | Equipped with 2 meters long X500MM wide stainless steel patterned plate, bearing 200KG |
Details
|
|
Large Walk-in Environmental Test Chamber Walk-in Climate Test Chamber Images
|
